In legacy mode (non DT mode) support only composite connector type. The only user for this is rx51, using composite type. Dropping the connector_type selection via pdata will allow cleanups in omapdss (drm vs fbdev).
Signed-off-by: Peter Ujfalusi peter.ujfalusi@ti.com --- drivers/video/fbdev/omap2/omapfb/displays/connector-analog-tv.c | 8 +------- 1 file changed, 1 insertion(+), 7 deletions(-)
diff --git a/drivers/video/fbdev/omap2/omapfb/displays/connector-analog-tv.c b/drivers/video/fbdev/omap2/omapfb/displays/connector-analog-tv.c index 8511c648a15c..d963b4a9cfc0 100644 --- a/drivers/video/fbdev/omap2/omapfb/displays/connector-analog-tv.c +++ b/drivers/video/fbdev/omap2/omapfb/displays/connector-analog-tv.c @@ -25,7 +25,6 @@ struct panel_drv_data {
struct omap_video_timings timings;
- enum omap_dss_venc_type connector_type; bool invert_polarity; };
@@ -45,10 +44,6 @@ static const struct omap_video_timings tvc_pal_timings = {
static const struct of_device_id tvc_of_match[];
-struct tvc_of_data { - enum omap_dss_venc_type connector_type; -}; - #define to_panel_data(x) container_of(x, struct panel_drv_data, dssdev)
static int tvc_connect(struct omap_dss_device *dssdev) @@ -99,7 +94,7 @@ static int tvc_enable(struct omap_dss_device *dssdev) in->ops.atv->set_timings(in, &ddata->timings);
if (!ddata->dev->of_node) { - in->ops.atv->set_type(in, ddata->connector_type); + in->ops.atv->set_type(in, OMAP_DSS_VENC_TYPE_COMPOSITE);
in->ops.atv->invert_vid_out_polarity(in, ddata->invert_polarity); @@ -207,7 +202,6 @@ static int tvc_probe_pdata(struct platform_device *pdev)
ddata->in = in;
- ddata->connector_type = pdata->connector_type; ddata->invert_polarity = pdata->invert_polarity;
dssdev = &ddata->dssdev;