The gpio1 0 pin is controlling CAN termination, not USB H1 VBUS. So, remove wrong regulator and assign this GPIO to the new DT CAN termination property.
Signed-off-by: Oleksij Rempel o.rempel@pengutronix.de --- arch/arm/boot/dts/imx6qdl-vicut1.dtsi | 12 ++---------- 1 file changed, 2 insertions(+), 10 deletions(-)
diff --git a/arch/arm/boot/dts/imx6qdl-vicut1.dtsi b/arch/arm/boot/dts/imx6qdl-vicut1.dtsi index b9e305774fed..1ac7e13249d2 100644 --- a/arch/arm/boot/dts/imx6qdl-vicut1.dtsi +++ b/arch/arm/boot/dts/imx6qdl-vicut1.dtsi @@ -126,15 +126,6 @@ reg_3v3: regulator-3v3 { regulator-max-microvolt = <3300000>; };
- reg_h1_vbus: regulator-h1-vbus { - compatible = "regulator-fixed"; - regulator-name = "h1-vbus"; - regulator-min-microvolt = <5000000>; - regulator-max-microvolt = <5000000>; - gpio = <&gpio1 0 GPIO_ACTIVE_HIGH>; - enable-active-high; - }; - reg_otg_vbus: regulator-otg-vbus { compatible = "regulator-fixed"; regulator-name = "otg-vbus"; @@ -212,6 +203,8 @@ IMX_AUDMUX_V2_PTCR_SYN IMX_AUDMUX_V2_PDCR_RXDSEL(0) &can1 { pinctrl-names = "default"; pinctrl-0 = <&pinctrl_can1>; + termination-gpios = <&gpio1 0 GPIO_ACTIVE_LOW>; + termination-ohms = <150>; status = "okay"; };
@@ -492,7 +485,6 @@ &uart5 { };
&usbh1 { - vbus-supply = <®_h1_vbus>; pinctrl-names = "default"; phy_type = "utmi"; dr_mode = "host";