On Mon, Feb 1, 2016 at 2:50 AM, Linus Walleij linus.walleij@linaro.org wrote:
This adds device tree bindings for the TPO TPG110 panel found mounted in the Nomadik NHK8815.
Signed-off-by: Linus Walleij linus.walleij@linaro.org
.../bindings/display/panel/tpo,tpg110.txt | 47 ++++++++++++++++++++++ 1 file changed, 47 insertions(+) create mode 100644 Documentation/devicetree/bindings/display/panel/tpo,tpg110.txt
diff --git a/Documentation/devicetree/bindings/display/panel/tpo,tpg110.txt b/Documentation/devicetree/bindings/display/panel/tpo,tpg110.txt new file mode 100644 index 000000000000..acbc6bef3593 --- /dev/null +++ b/Documentation/devicetree/bindings/display/panel/tpo,tpg110.txt @@ -0,0 +1,47 @@ +TPO TPG110 Panel +================
+This binding builds on the DPI bindings, adding a few properties +as a superset of a DPI. See panel-dpi.txt for the required DPI +bindings.
+Required properties: +- compatible : "tpo,tpg110" +- grestb-gpio : panel reset GPIO
-gpios
The example is correct.
Otherwise,
Acked-by: Rob Herring robh@kernel.org
+- scen-gpios : serial control enable GPIO +- scl-gpios : serial control clock line GPIO +- sda-gpios : serial control data line GPIO
+Required nodes: +- Video port for DPI input, see panel-dpi.txt +- Panel timing for DPI setup, see panel-dpi.txt
+Example +-------
+panel {
compatible = "tpo,tpg110", "panel-dpi";grestb-gpios = <&stmpe_gpio44 5 GPIO_ACTIVE_LOW>;scen-gpios = <&gpio0 6 GPIO_ACTIVE_LOW>;scl-gpios = <&gpio0 5 GPIO_ACTIVE_HIGH>;sda-gpios = <&gpio0 4 GPIO_ACTIVE_HIGH>;backlight = <&bl>;port {nomadik_clcd_panel: endpoint {remote-endpoint = <&nomadik_clcd_pads>;};};panel-timing {clock-frequency = <33200000>;hactive = <800>;hback-porch = <216>;hfront-porch = <40>;hsync-len = <1>;vactive = <480>;vback-porch = <35>;vfront-porch = <10>;vsync-len = <1>;};+};
2.4.3