Add DRM/KMS driver bindings documentation. Describe the required properties for each of the hardware IPs drivers.
Signed-off-by: Benjamin Gaignard benjamin.gaignard@linaro.org --- .../devicetree/bindings/gpu/st,stih4xx.txt | 189 +++++++++++++++++++++ 1 file changed, 189 insertions(+) create mode 100644 Documentation/devicetree/bindings/gpu/st,stih4xx.txt
diff --git a/Documentation/devicetree/bindings/gpu/st,stih4xx.txt b/Documentation/devicetree/bindings/gpu/st,stih4xx.txt new file mode 100644 index 0000000..59a59a7 --- /dev/null +++ b/Documentation/devicetree/bindings/gpu/st,stih4xx.txt @@ -0,0 +1,189 @@ +STMicroelectronics stih4xx platforms + +- sti-vtg: video timing generator + Required properties: + - compatible: "st,vtg" + - reg: Physical base address of the IP registers and length of memory mapped region. + Optional properties: + - interrupts : VTG interrupt number to the CPU. + - st,slave: phandle on a slave vtg + +- sti-vtac: video timing advanced inter dye communication Rx and TX + Required properties: + - compatible: "st,vtac-main" or "st,vtac-aux" + - reg: Physical base address of the IP registers and length of memory mapped region. + - clocks: from common clock binding: handle hardware IP needed clocks, the + number of clocks may depend of the SoC type. + See ../clocks/clock-bindings.txt for details. + - clock-names: names of the clocks listed in clocks property in the same + order. + +- sti-display-subsystem: Master device for DRM sub-components + This device must be the parent of all the sub-components and is responsible + of bind them. + Required properties: + - compatible: "st,sti-display-subsystem" + - ranges: to allow probing of subdevices + +- sti-compositor: frame compositor engine + must be a child of sti-display-subsystem + Required properties: + - compatible: "st,stih<chip>-compositor" + - reg: Physical base address of the IP registers and length of memory mapped region. + - clocks: from common clock binding: handle hardware IP needed clocks, the + number of clocks may depend of the SoC type. + See ../clocks/clock-bindings.txt for details. + - clock-names: names of the clocks listed in clocks property in the same + order. + - resets: resets to be used by the device + See ../reset/reset.txt for details. + - reset-names: names of the resets listed in resets property in the same + order. + - st,vtg: phandle(s) on vtg device (main and aux) nodes. + +- sti-tvout: video out hardware block + must be a child of sti-display-subsystem + Required properties: + - compatible: "st,stih<chip>-tvout" + - reg: Physical base address of the IP registers and length of memory mapped region. + - reg-names: names of the mapped memory regions listed in regs property in + the same order. + - resets: resets to be used by the device + See ../reset/reset.txt for details. + - reset-names: names of the resets listed in resets property in the same + order. + - ranges: to allow probing of subdevices + +- sti-hdmi: hdmi output block + must be a child of sti-tvout + Required properties: + - compatible: "st,stih<chip>-hdmi"; + - reg: Physical base address of the IP registers and length of memory mapped region. + - reg-names: names of the mapped memory regions listed in regs property in + the same order. + - interrupts : HDMI interrupt number to the CPU. + - interrupt-names: name of the interrupts listed in interrupts property in + the same order + - clocks: from common clock binding: handle hardware IP needed clocks, the + number of clocks may depend of the SoC type. + - clock-names: names of the clocks listed in clocks property in the same + order. + - hdmi,hpd-gpio: gpio id to detect if an hdmi cable is plugged or not. + +sti-hda: + Required properties: + must be a child of sti-tvout + - compatible: "st,stih<chip>-hda" + - reg: Physical base address of the IP registers and length of memory mapped region. + - reg-names: names of the mapped memory regions listed in regs property in + the same order. + - clocks: from common clock binding: handle hardware IP needed clocks, the + number of clocks may depend of the SoC type. + See ../clocks/clock-bindings.txt for details. + - clock-names: names of the clocks listed in clocks property in the same + order. + +Example: + +/ { + ... + + vtg_main_slave: sti-vtg-main-slave@fe85A800 { + compatible = "st,vtg"; + reg = <0xfe85A800 0x300>; + interrupts = <GIC_SPI 175 IRQ_TYPE_NONE>; + }; + + vtg_main: sti-vtg-main-master@fd348000 { + compatible = "st,vtg"; + reg = <0xfd348000 0x400>; + st,slave = <&vtg_main_slave>; + }; + + vtg_aux_slave: sti-vtg-aux-slave@fd348400 { + compatible = "st,vtg"; + reg = <0xfe858200 0x300>; + interrupts = <GIC_SPI 176 IRQ_TYPE_NONE>; + }; + + vtg_aux: sti-vtg-aux-master@fd348400 { + compatible = "st,vtg"; + reg = <0xfd348400 0x400>; + st,slave = <&vtg_aux_slave>; + }; + + + sti-vtac-rx-main@fee82800 { + compatible = "st,vtac-main"; + reg = <0xfee82800 0x200>; + clock-names = "vtac"; + clocks = <&CLK_M_A2_DIV0 CLK_M_VTAC_MAIN_PHY>; + }; + + sti-vtac-rx-aux@fee82a00 { + compatible = "st,vtac-aux"; + reg = <0xfee82a00 0x200>; + clock-names = "vtac"; + clocks = <&CLK_M_A2_DIV0 CLK_M_VTAC_AUX_PHY>; + }; + + sti-vtac-tx-main@fd349000 { + compatible = "st,vtac-main"; + reg = <0xfd349000 0x200>, <0xfd320000 0x10000>; + clock-names = "vtac"; + clocks = <&CLK_S_A1_HS CLK_S_VTAC_TX_PHY>; + }; + + sti-vtac-tx-aux@fd349200 { + compatible = "st,vtac-aux"; + reg = <0xfd349200 0x200>, <0xfd320000 0x10000>; + clock-names = "vtac"; + clocks = <&CLK_S_A1_HS CLK_S_VTAC_TX_PHY>; + }; + + sti-display-subsystem { + compatible = "st,sti-display-subsystem"; + ranges; + + sti-compositor@fd340000 { + compatible = "st,stih416-compositor"; + reg = <0xfd340000 0x1000>; + clock-names = "compo_main", "compo_aux", + "pix_main", "pix_aux"; + clocks = <&CLK_M_A2_DIV1 CLK_M_COMPO_MAIN>, <&CLK_M_A2_DIV1 CLK_M_COMPO_AUX>, + <&CLOCKGEN_C_VCC CLK_S_PIX_MAIN>, <&CLOCKGEN_C_VCC CLK_S_PIX_AUX>; + reset-names = "compo-main", "compo-aux"; + resets = <&softreset STIH416_COMPO_M_SOFTRESET>, <&softreset STIH416_COMPO_A_SOFTRESET>; + st,vtg = <&vtg_main>, <&vtg_aux>; + }; + + sti-tvout@fe000000 { + compatible = "st,stih416-tvout"; + reg = <0xfe000000 0x1000>, <0xfe85a000 0x400>, <0xfe830000 0x10000>; + reg-names = "tvout-reg", "hda-reg", "syscfg"; + reset-names = "tvout"; + resets = <&softreset STIH416_HDTVOUT_SOFTRESET>; + ranges; + + sti-hdmi@fe85c000 { + compatible = "st,stih416-hdmi"; + reg = <0xfe85c000 0x1000>, <0xfe830000 0x10000>; + reg-names = "hdmi-reg", "syscfg"; + interrupts = <GIC_SPI 173 IRQ_TYPE_NONE>; + interrupt-names = "irq"; + clock-names = "pix", "tmds", "phy", "audio"; + clocks = <&CLOCKGEN_C_VCC CLK_S_PIX_HDMI>, <&CLOCKGEN_C_VCC CLK_S_TMDS_HDMI>, <&CLOCKGEN_C_VCC CLK_S_HDMI_REJECT_PLL>, <&CLOCKGEN_B1 CLK_S_PCM_0>; + hdmi,hpd-gpio = <&PIO2 5>; + }; + + sti-hda@fe85a000 { + compatible = "st,stih416-hda"; + reg = <0xfe85a000 0x400>, <0xfe83085c 0x4>; + reg-names = "hda-reg", "video-dacs-ctrl"; + clock-names = "pix", "hddac"; + clocks = <&CLOCKGEN_C_VCC CLK_S_PIX_HD>, <&CLOCKGEN_C_VCC CLK_S_HDDAC>; + }; + }; + }; + ... +};