24.12.2020 09:43, Viresh Kumar пишет:
On 23-12-20, 23:37, Dmitry Osipenko wrote:
23.12.2020 07:19, Viresh Kumar пишет:
On 22-12-20, 22:15, Dmitry Osipenko wrote:
22.12.2020 09:42, Viresh Kumar пишет:
On 17-12-20, 21:06, Dmitry Osipenko wrote:
Add a ceil version of the dev_pm_opp_find_level(). It's handy to have if levels don't start from 0 in OPP table and zero usually means a minimal level.
Signed-off-by: Dmitry Osipenko digetx@gmail.com
Why doesn't the exact version work for you here ?
The exact version won't find OPP for level=0 if levels don't start with 0, where 0 means that minimal level is desired.
Right, but why do you need to send 0 for your platform ?
To put power domain into the lowest performance state when device is idling.
I see. So you really want to set it to the lowest state or just take the vote out ? Which may end up powering off the domain in the worst case ?
In a device driver I want to set PD to the lowest performance state by removing the performance vote when dev_pm_opp_set_rate(dev, 0) is invoked by the driver.
The OPP core already does this, but if OPP levels don't start from 0 in a device-tree for PD, then it currently doesn't work since there is a need to get a rounded-up performance state because dev_pm_opp_set_voltage() takes OPP entry for the argument (patches 9 and 28).
The PD powering off and performance-changes are separate from each other in the GENPD core. The GENPD core automatically turns off domain when all devices within the domain are suspended by system-suspend or RPM.
The performance state of a power domain is controlled solely by a device driver. GENPD core only aggregates the performance requests, it doesn't change the performance state of a domain by itself when device is suspended or resumed, IIUC this is intentional. And I want to put domain into lowest performance state when device is suspended.