On Wed, 31 Aug 2016 11:29:53 +0900 Hyung Jin Jung realbright@lgcns.com wrote:
According to Atmel's guideline... http://www.at91.com/linux4sam/bin/view/Linux4SAM/UsingAtmelDRMDriver
the "fbdev emulation mode" could be set from kernel command line (LVDS-1:...) however, driver register it as DRM_MODE_CONNECTOR_Unknown connector.
Just adapt the command line with Unknown-1:...
Actually we using sama5d3x with LVDS cable so that below patch would be correct.
No it wouldn't. The sama5 SoC is providing a raw RGB interface, so if you really have an LVDS interface on your board this means you have a bridge in the middle. This bridge should be represented in the DT, and attached to a driver in the kernel.
But I don't know the other case such as HDMI, composite...
Do we need to consider using DT or auto-detection??
Signed-off-by: HyungJin Jung realbright@lgcns.com
drivers/gpu/drm/atmel-hlcdc/atmel_hlcdc_output.c | 1 + 1 file changed, 1 insertion(+)
diff --git a/drivers/gpu/drm/atmel-hlcdc/atmel_hlcdc_output.c b/drivers/gpu/drm/atmel-hlcdc/atmel_hlcdc_output.c index 6119b50..da97efe --- a/drivers/gpu/drm/atmel-hlcdc/atmel_hlcdc_output.c +++ b/drivers/gpu/drm/atmel-hlcdc/atmel_hlcdc_output.c @@ -208,7 +208,7 @@ static int atmel_hlcdc_attach_endpoint(struct drm_device *dev, &atmel_hlcdc_panel_connector_helper_funcs); ret = drm_connector_init(dev, &output->connector, &atmel_hlcdc_panel_connector_funcs,
DRM_MODE_CONNECTOR_Unknown);
DRM_MODE_CONNECTOR_LVDS);