The HLCDC IP available in some Atmel SoCs (i.e. sam9x5i.e. at91sam9n12, at91sam9x5 family or sama5d3 family) provide a PWM device.
The DT bindings used for this PWM device is following the default 3 cells bindings described in Documentation/devicetree/bindings/pwm/pwm.txt.
Signed-off-by: Boris BREZILLON boris.brezillon@free-electrons.com --- .../devicetree/bindings/pwm/atmel-hlcdc-pwm.txt | 55 ++++++++++++++++++++++ 1 file changed, 55 insertions(+) create mode 100644 Documentation/devicetree/bindings/pwm/atmel-hlcdc-pwm.txt
diff --git a/Documentation/devicetree/bindings/pwm/atmel-hlcdc-pwm.txt b/Documentation/devicetree/bindings/pwm/atmel-hlcdc-pwm.txt new file mode 100644 index 0000000..86ad3e2 --- /dev/null +++ b/Documentation/devicetree/bindings/pwm/atmel-hlcdc-pwm.txt @@ -0,0 +1,55 @@ +Device-Tree bindings for Atmel's HLCDC (High LCD Controller) PWM driver + +The Atmel HLCDC PWM is subdevice of the HLCDC MFD device. +See ../mfd/atmel-hlcdc.txt for more details. + +Required properties: + - compatible: value should be one of the following: + "atmel,hlcdc-pwm" + - pinctr-names: the pin control state names. Should contain "default". + - pinctrl-0: should contain the pinctrl states described by pinctrl + default. + - #pwm-cells: should be set to 3. This PWM chip use the default 3 cells + bindings defined in Documentation/devicetree/bindings/pwm/pwm.txt. + The first cell encodes the PWM id (0 is the only acceptable value here, + because the chip only provide one PWM). + The second cell encodes the PWM period in nanoseconds. + The third cell encodes the PWM flags (the only supported flag is + PWM_POLARITY_INVERTED) + +Example: + + hlcdc: hlcdc@f0030000 { + compatible = "atmel,sama5d3-hlcdc"; + reg = <0xf0030000 0x2000>; + clocks = <&lcdc_clk>, <&lcdck>, <&clk32k>; + clock-names = "periph_clk","sys_clk", "slow_clk"; + status = "disabled"; + + hlcdc-display-controller { + compatible = "atmel,hlcdc-display-controller"; + interrupts = <36 IRQ_TYPE_LEVEL_HIGH 0>; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_lcd_base &pinctrl_lcd_rgb888>; + #address-cells = <1>; + #size-cells = <0>; + + port@0 { + #address-cells = <1>; + #size-cells = <0>; + reg = <0>; + + hlcdc_panel_output: endpoint@0 { + reg = <0>; + remote-endpoint = <&panel_input>; + }; + }; + }; + + hlcdc_pwm: hlcdc-pwm { + compatible = "atmel,hlcdc-pwm"; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_lcd_pwm>; + #pwm-cells = <3>; + }; + };