On 16/04/2021 11:58, Laurent Pinchart wrote:
Hi Neil,
On Fri, Apr 16, 2021 at 11:27:35AM +0200, Neil Armstrong wrote:
This adds DW-HDMI driver a glue option to disable loading of the CEC sub-driver.
On some SoCs, the CEC functionality is enabled in the IP config bits, but the CEC bus is non-functional like on Amlogic SoCs, where the CEC config bit is set but the DW-HDMI CEC signal is not connected to a physical pin, leading to some confusion when the DW-HDMI CEC controller can't communicate on the bus.
If we can't trust the CEC config bit, would it be better to not use it at all, and instead let each platform glue logic tell whether to enable CEC or not ?
Actually, the CEC config bit is right, the HW exists and should be functional, but this bit doesn't tell if the CEC signal is connected to something.
This lies in the IP integration, like other bits under the "amlogic,meson-*-dw-hdmi" umbrella.
The first attempt was by Hans using DT, but adding a property in DT for a vendor specific compatible doesn't make sense. Another idea would be to describe the CEC signal endpoint like we do for video signal, but I think this is out of scope and this solution is much simpler and straightforward, and it's more an exception than a general use case to solve.
Neil
Jernej Skrabec (1): drm/bridge/synopsys: dw-hdmi: Add an option to suppress loading CEC driver
Neil Armstrong (1): drm/meson: dw-hdmi: disable DW-HDMI CEC sub-driver
drivers/gpu/drm/bridge/synopsys/dw-hdmi.c | 2 +- drivers/gpu/drm/meson/meson_dw_hdmi.c | 1 + include/drm/bridge/dw_hdmi.h | 2 ++ 3 files changed, 4 insertions(+), 1 deletion(-)