* Tomi Valkeinen tomi.valkeinen@ideasonboard.com [210211 07:35]:
On 08/02/2021 19:55, Tony Lindgren wrote:
Hi,
- Tomi Valkeinen tomi.valkeinen@ti.com [201124 12:47]:
From: Sebastian Reichel sebastian.reichel@collabora.com
In preparation for removing custom DSS calls from the DSI panel driver, this moves support for external tearing event GPIOs into the DSI host driver. This way tearing events are always handled in the core resulting in simplification of the panel drivers.
The TE GPIO acquisition follows works in the same way as the exynos DSI implementation.
Looks like this patch causes the following warnings:
DSI: omapdss DSI error: Failed to receive BTA DSI: omapdss DSI error: bta sync failed DSI: omapdss DSI error: vc(0) busy when trying to config for VP DSI: omapdss DSI error: Failed to receive BTA DSI: omapdss DSI error: bta sync failed DSI: omapdss DSI error: vc(0) busy when trying to config for VP DSI: omapdss DSI error: Failed to receive BTA DSI: omapdss DSI error: bta sync failed DSI: omapdss DSI error: vc(0) busy when trying to config for VP ...
Any ideas? The display works for me despite the constant warnings.
Which board is that? Do the errors start right from the boot, or only after running something in userspace?
This is with droid4, that's about the only device I use with a display on regular basis. I'm pretty sure some earlier version of Sebastian's patches worked fine.
Regards,
Tony