On 07/10/2017 03:12 AM, Rob Herring wrote:
On Tue, Jul 04, 2017 at 06:30:04PM +0200, Philippe CORNU wrote:
The Orise Tech OTM8009A is a 3.97" 480x800 TFT LCD panel connected using a MIPI-DSI video interface. Its backlight is managed through the DSI link.
Signed-off-by: Philippe CORNU philippe.cornu@st.com
.../bindings/display/panel/orisetech,otm8009a.txt | 20 ++++++++++++++++++++ 1 file changed, 20 insertions(+) create mode 100644 Documentation/devicetree/bindings/display/panel/orisetech,otm8009a.txt
diff --git a/Documentation/devicetree/bindings/display/panel/orisetech,otm8009a.txt b/Documentation/devicetree/bindings/display/panel/orisetech,otm8009a.txt new file mode 100644 index 0000000..0bb8237 --- /dev/null +++ b/Documentation/devicetree/bindings/display/panel/orisetech,otm8009a.txt @@ -0,0 +1,20 @@ +Orise Tech OTM8009A 3.97" 480x800 TFT LCD panel (MIPI-DSI video mode)
+The Orise Tech OTM8009A is a 3.97" 480x800 TFT LCD panel connected using +a MIPI-DSI video interface. Its backlight is managed through the DSI link.
+Required properties:
- compatible: "orisetech,otm8009a"
- reg: the virtual channel number of a DSI peripheral
- reset-gpios: a GPIO spec for the reset pin (active low). (Optional)
If this is optional, move it to its own section.
Dear Rob, Many thanks for your comment. Fixed in v2, sent few minutes ago. Best regards, Philippe
+Example: +&dsi {
- ...
- panel@0 {
compatible = "orisetech,otm8009a";reg = <0>;reset-gpios = <&gpioh 7 0>;- };
+};
1.9.1