Re: [PATCH 5/4] dt-bindings: display: bridge: thc63lvd1024: Document dual-output mode

Hi Laurent,

On Thu, May 14, 2020 at 02:21:27AM +0300, Laurent Pinchart wrote:

The DT binding support both dual-input and dual-output mode, but only dual-input is documented. Document dual-output mode.

Suggested-by: Jacopo Mondi jacopo+renesas@jmondi.org Signed-off-by: Laurent Pinchart laurent.pinchart+renesas@ideasonboard.com

Thanks Acked-by: Jacopo Mondi jacopo@jmondi.org

---

.../display/bridge/thine,thc63lvd1024.yaml | 16 +++++++++++----- 1 file changed, 11 insertions(+), 5 deletions(-)

diff --git a/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.yaml b/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.yaml index 469ac4a34273..fedd3460d6f6 100644 --- a/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.yaml +++ b/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.yaml @@ -30,11 +30,17 @@ properties: This device has four video ports. Their connections are modeled using the OF graph bindings specified in Documentation/devicetree/bindings/graph.txt.

•  The device can operate in single-link mode or dual-link mode. In
  

•  single-link mode, all pixels are received on port@0, and port@1 shall not
  

•  contain any endpoint. In dual-link mode, even-numbered pixels are
  

•  received on port@0 and odd-numbered pixels on port@1, and both port@0 and
  

•  port@1 shall contain endpoints.
  

•  The device can operate in single or dual input and output modes.
  

•  When operating in single input mode, all pixels are received on port@0,
  

•  and port@1 shall not contain any endpoint. In dual input mode,
  

•  even-numbered pixels are received on port@0 and odd-numbered pixels on
  

•  port@1, and both port@0 and port@1 shall contain endpoints.
  

•  When operating in single output mode all pixels are output from the first
  

•  CMOS/TTL port and port@3 shall not contain any endpoint. In dual output
  

•  mode pixels are output from both CMOS/TTL ports and both port@2 and
  

•  port@3 shall contain endpoints.
  
  

  properties: '#address-cells':

-- Regards,

Laurent Pinchart