There's no reason to check for an active encoder when setting up hpd, especially since a disconnected connector isn't going to have an encoder in the first place. This fixes reprobing display connectors on resume.
Signed-off-by: Lyude cpaul@redhat.com --- After some talking with danvet on IRC, I learned that calling drm_helper_hpd_irq_event() does actually trigger a full reprobe of each connector's status. It turns out this is the actual reason reprobing on resume hasn't been working (this was observed on a T440s):
- We call hpd_init() - We check each connector for a couple of things before marking connector->polled with DRM_CONNECTOR_POLL_HPD, one of which is an active encoder. Of course, a disconnected port won't have an active encoder, so we don't add the flag to any of the connector's. - We call drm_helper_hpd_irq_event() - drm_helper_irq_event() checks each connector for the DRM_CONNECTOR_POLL_HPD flag. The only one that has it is eDP-1, so we skip reprobing each connector except that one.
drivers/gpu/drm/i915/intel_hotplug.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/gpu/drm/i915/intel_hotplug.c b/drivers/gpu/drm/i915/intel_hotplug.c index b177857..18797bc 100644 --- a/drivers/gpu/drm/i915/intel_hotplug.c +++ b/drivers/gpu/drm/i915/intel_hotplug.c @@ -468,7 +468,7 @@ void intel_hpd_init(struct drm_i915_private *dev_priv) list_for_each_entry(connector, &mode_config->connector_list, head) { struct intel_connector *intel_connector = to_intel_connector(connector); connector->polled = intel_connector->polled; - if (connector->encoder && !connector->polled && I915_HAS_HOTPLUG(dev) && intel_connector->encoder->hpd_pin > HPD_NONE) + if (!connector->polled && I915_HAS_HOTPLUG(dev) && intel_connector->encoder->hpd_pin > HPD_NONE) connector->polled = DRM_CONNECTOR_POLL_HPD; if (intel_connector->mst_port) connector->polled = DRM_CONNECTOR_POLL_HPD;