Currently, the MXSFB DRM driver only supports a panel. But, its output display signal can also be redirected to another encoder, like a DSI controller. In this case, that DSI controller may act like a drm_bridge. In order support this use-case too, this patch adds support for drm_bridge in mxsfb.
Signed-off-by: Robert Chiras robert.chiras@nxp.com Tested-by: Guido Günther agx@sigxcpu.org --- drivers/gpu/drm/mxsfb/mxsfb_crtc.c | 17 +++++++++++--- drivers/gpu/drm/mxsfb/mxsfb_drv.c | 46 +++++++++++++++++++++++++++++++++----- drivers/gpu/drm/mxsfb/mxsfb_drv.h | 4 +++- drivers/gpu/drm/mxsfb/mxsfb_out.c | 26 +++++++++++---------- 4 files changed, 72 insertions(+), 21 deletions(-)
diff --git a/drivers/gpu/drm/mxsfb/mxsfb_crtc.c b/drivers/gpu/drm/mxsfb/mxsfb_crtc.c index 1242156..de09b93 100644 --- a/drivers/gpu/drm/mxsfb/mxsfb_crtc.c +++ b/drivers/gpu/drm/mxsfb/mxsfb_crtc.c @@ -95,8 +95,11 @@ static void mxsfb_set_bus_fmt(struct mxsfb_drm_private *mxsfb)
reg = readl(mxsfb->base + LCDC_CTRL);
- if (mxsfb->connector.display_info.num_bus_formats) - bus_format = mxsfb->connector.display_info.bus_formats[0]; + if (mxsfb->connector->display_info.num_bus_formats) + bus_format = mxsfb->connector->display_info.bus_formats[0]; + + DRM_DEV_DEBUG_DRIVER(drm->dev, "Using bus_format: 0x%08X\n", + bus_format);
reg &= ~CTRL_BUS_WIDTH_MASK; switch (bus_format) { @@ -204,8 +207,9 @@ static dma_addr_t mxsfb_get_fb_paddr(struct mxsfb_drm_private *mxsfb)
static void mxsfb_crtc_mode_set_nofb(struct mxsfb_drm_private *mxsfb) { + struct drm_device *drm = mxsfb->pipe.crtc.dev; struct drm_display_mode *m = &mxsfb->pipe.crtc.state->adjusted_mode; - const u32 bus_flags = mxsfb->connector.display_info.bus_flags; + const u32 bus_flags = mxsfb->connector->display_info.bus_flags; u32 vdctrl0, vsync_pulse_len, hsync_pulse_len; int err;
@@ -229,6 +233,13 @@ static void mxsfb_crtc_mode_set_nofb(struct mxsfb_drm_private *mxsfb)
clk_set_rate(mxsfb->clk, m->crtc_clock * 1000);
+ DRM_DEV_DEBUG_DRIVER(drm->dev, "Pixel clock: %dkHz (actual: %dkHz)\n", + m->crtc_clock, + (int)(clk_get_rate(mxsfb->clk) / 1000)); + DRM_DEV_DEBUG_DRIVER(drm->dev, "Connector bus_flags: 0x%08X\n", + bus_flags); + DRM_DEV_DEBUG_DRIVER(drm->dev, "Mode flags: 0x%08X\n", m->flags); + writel(TRANSFER_COUNT_SET_VCOUNT(m->crtc_vdisplay) | TRANSFER_COUNT_SET_HCOUNT(m->crtc_hdisplay), mxsfb->base + mxsfb->devdata->transfer_count); diff --git a/drivers/gpu/drm/mxsfb/mxsfb_drv.c b/drivers/gpu/drm/mxsfb/mxsfb_drv.c index 878ef68..9dc69b7 100644 --- a/drivers/gpu/drm/mxsfb/mxsfb_drv.c +++ b/drivers/gpu/drm/mxsfb/mxsfb_drv.c @@ -101,9 +101,25 @@ static void mxsfb_pipe_enable(struct drm_simple_display_pipe *pipe, struct drm_crtc_state *crtc_state, struct drm_plane_state *plane_state) { + struct drm_connector *connector; struct mxsfb_drm_private *mxsfb = drm_pipe_to_mxsfb_drm_private(pipe); struct drm_device *drm = pipe->plane.dev;
+ if (!mxsfb->connector) { + list_for_each_entry(connector, + &drm->mode_config.connector_list, + head) + if (connector->encoder == &mxsfb->pipe.encoder) { + mxsfb->connector = connector; + break; + } + } + + if (!mxsfb->connector) { + dev_warn(drm->dev, "No connector attached, using default\n"); + mxsfb->connector = &mxsfb->panel_connector; + } + pm_runtime_get_sync(drm->dev); drm_panel_prepare(mxsfb->panel); mxsfb_crtc_enable(mxsfb); @@ -129,6 +145,9 @@ static void mxsfb_pipe_disable(struct drm_simple_display_pipe *pipe) drm_crtc_send_vblank_event(crtc, event); } spin_unlock_irq(&drm->event_lock); + + if (mxsfb->connector != &mxsfb->panel_connector) + mxsfb->connector = NULL; }
static void mxsfb_pipe_update(struct drm_simple_display_pipe *pipe, @@ -226,16 +245,33 @@ static int mxsfb_load(struct drm_device *drm, unsigned long flags)
ret = drm_simple_display_pipe_init(drm, &mxsfb->pipe, &mxsfb_funcs, mxsfb_formats, ARRAY_SIZE(mxsfb_formats), NULL, - &mxsfb->connector); + mxsfb->connector); if (ret < 0) { dev_err(drm->dev, "Cannot setup simple display pipe\n"); goto err_vblank; }
- ret = drm_panel_attach(mxsfb->panel, &mxsfb->connector); - if (ret) { - dev_err(drm->dev, "Cannot connect panel\n"); - goto err_vblank; + /* + * Attach panel only if there is one. + * If there is no panel attach, it must be a bridge. In this case, we + * need a reference to its connector for a proper initialization. + * We will do this check in pipe->enable(), since the connector won't + * be attached to an encoder until then. + */ + + if (mxsfb->panel) { + ret = drm_panel_attach(mxsfb->panel, mxsfb->connector); + if (ret) { + dev_err(drm->dev, "Cannot connect panel: %d\n", ret); + goto err_vblank; + } + } else if (mxsfb->bridge) { + ret = drm_simple_display_pipe_attach_bridge(&mxsfb->pipe, + mxsfb->bridge); + if (ret) { + dev_err(drm->dev, "Cannot connect bridge: %d\n", ret); + goto err_vblank; + } }
drm->mode_config.min_width = MXSFB_MIN_XRES; diff --git a/drivers/gpu/drm/mxsfb/mxsfb_drv.h b/drivers/gpu/drm/mxsfb/mxsfb_drv.h index d975300..0b65b51 100644 --- a/drivers/gpu/drm/mxsfb/mxsfb_drv.h +++ b/drivers/gpu/drm/mxsfb/mxsfb_drv.h @@ -27,8 +27,10 @@ struct mxsfb_drm_private { struct clk *clk_disp_axi;
struct drm_simple_display_pipe pipe; - struct drm_connector connector; + struct drm_connector panel_connector; + struct drm_connector *connector; struct drm_panel *panel; + struct drm_bridge *bridge; };
int mxsfb_setup_crtc(struct drm_device *dev); diff --git a/drivers/gpu/drm/mxsfb/mxsfb_out.c b/drivers/gpu/drm/mxsfb/mxsfb_out.c index 231d016..9506eec 100644 --- a/drivers/gpu/drm/mxsfb/mxsfb_out.c +++ b/drivers/gpu/drm/mxsfb/mxsfb_out.c @@ -21,7 +21,8 @@ static struct mxsfb_drm_private * drm_connector_to_mxsfb_drm_private(struct drm_connector *connector) { - return container_of(connector, struct mxsfb_drm_private, connector); + return container_of(connector, struct mxsfb_drm_private, + panel_connector); }
static int mxsfb_panel_get_modes(struct drm_connector *connector) @@ -76,22 +77,23 @@ static const struct drm_connector_funcs mxsfb_panel_connector_funcs = { int mxsfb_create_output(struct drm_device *drm) { struct mxsfb_drm_private *mxsfb = drm->dev_private; - struct drm_panel *panel; int ret;
- ret = drm_of_find_panel_or_bridge(drm->dev->of_node, 0, 0, &panel, NULL); + ret = drm_of_find_panel_or_bridge(drm->dev->of_node, 0, 0, + &mxsfb->panel, &mxsfb->bridge); if (ret) return ret;
- mxsfb->connector.dpms = DRM_MODE_DPMS_OFF; - mxsfb->connector.polled = 0; - drm_connector_helper_add(&mxsfb->connector, - &mxsfb_panel_connector_helper_funcs); - ret = drm_connector_init(drm, &mxsfb->connector, - &mxsfb_panel_connector_funcs, - DRM_MODE_CONNECTOR_Unknown); - if (!ret) - mxsfb->panel = panel; + if (mxsfb->panel) { + mxsfb->connector = &mxsfb->panel_connector; + mxsfb->connector->dpms = DRM_MODE_DPMS_OFF; + mxsfb->connector->polled = 0; + drm_connector_helper_add(mxsfb->connector, + &mxsfb_panel_connector_helper_funcs); + ret = drm_connector_init(drm, mxsfb->connector, + &mxsfb_panel_connector_funcs, + DRM_MODE_CONNECTOR_Unknown); + }
return ret; }