The VID_CTL setup is done in several places in the driver even though it's not really required. Let's simplify it a bit to do the configuration in one go.
Signed-off-by: Maxime Ripard maxime@cerno.tech --- drivers/gpu/drm/vc4/vc4_hdmi.c | 14 ++++++-------- 1 file changed, 6 insertions(+), 8 deletions(-)
diff --git a/drivers/gpu/drm/vc4/vc4_hdmi.c b/drivers/gpu/drm/vc4/vc4_hdmi.c index bbe521ab000b..f56a718a3643 100644 --- a/drivers/gpu/drm/vc4/vc4_hdmi.c +++ b/drivers/gpu/drm/vc4/vc4_hdmi.c @@ -428,10 +428,6 @@ static void vc4_hdmi_set_timings(struct vc4_hdmi *vc4_hdmi,
HDMI_WRITE(HDMI_VERTB0, vertb_even); HDMI_WRITE(HDMI_VERTB1, vertb); - - HDMI_WRITE(HDMI_VID_CTL, - (vsync_pos ? 0 : VC4_HD_VID_CTL_VSYNC_LOW) | - (hsync_pos ? 0 : VC4_HD_VID_CTL_HSYNC_LOW)); }
static void vc4_hdmi_recenter_fifo(struct vc4_hdmi *vc4_hdmi) @@ -520,8 +516,6 @@ static void vc4_hdmi_encoder_pre_crtc_configure(struct drm_encoder *encoder) if (vc4_hdmi->variant->phy_init) vc4_hdmi->variant->phy_init(vc4_hdmi, mode);
- HDMI_WRITE(HDMI_VID_CTL, 0); - HDMI_WRITE(HDMI_SCHEDULER_CONTROL, HDMI_READ(HDMI_SCHEDULER_CONTROL) | VC4_HDMI_SCHEDULER_CONTROL_MANUAL_FORMAT | @@ -555,15 +549,19 @@ static void vc4_hdmi_encoder_pre_crtc_enable(struct drm_encoder *encoder)
static void vc4_hdmi_encoder_post_crtc_enable(struct drm_encoder *encoder) { + struct drm_display_mode *mode = &encoder->crtc->state->adjusted_mode; struct vc4_hdmi *vc4_hdmi = encoder_to_vc4_hdmi(encoder); struct vc4_hdmi_encoder *vc4_encoder = to_vc4_hdmi_encoder(encoder); + bool hsync_pos = mode->flags & DRM_MODE_FLAG_PHSYNC; + bool vsync_pos = mode->flags & DRM_MODE_FLAG_PVSYNC; int ret;
HDMI_WRITE(HDMI_VID_CTL, - HDMI_READ(HDMI_VID_CTL) | VC4_HD_VID_CTL_ENABLE | VC4_HD_VID_CTL_UNDERFLOW_ENABLE | - VC4_HD_VID_CTL_FRAME_COUNTER_RESET); + VC4_HD_VID_CTL_FRAME_COUNTER_RESET | + (vsync_pos ? 0 : VC4_HD_VID_CTL_VSYNC_LOW) | + (hsync_pos ? 0 : VC4_HD_VID_CTL_HSYNC_LOW));
if (vc4_encoder->hdmi_monitor) { HDMI_WRITE(HDMI_SCHEDULER_CONTROL,