From: Darren Etheridge detheridge@ti.com
The frame_done interrupt was only being enabled when the vsync interrupts were being enabled by DRM. However the frame_done is used to determine if the LCD controller has successfully completed the raster_enable, raster_disable commands and the vsync interrupts are not always enabled during these operations.
Signed-off-by: Darren Etheridge detheridge@ti.com Tested-by: Dave Gerlach d-gerlach@ti.com Signed-off-by: Jyri Sarha jsarha@ti.com --- drivers/gpu/drm/tilcdc/tilcdc_drv.c | 6 ++++-- 1 file changed, 4 insertions(+), 2 deletions(-)
diff --git a/drivers/gpu/drm/tilcdc/tilcdc_drv.c b/drivers/gpu/drm/tilcdc/tilcdc_drv.c index 188c3ce..149befa 100644 --- a/drivers/gpu/drm/tilcdc/tilcdc_drv.c +++ b/drivers/gpu/drm/tilcdc/tilcdc_drv.c @@ -384,7 +384,9 @@ static int tilcdc_irq_postinstall(struct drm_device *dev) if (priv->rev == 1) tilcdc_set(dev, LCDC_RASTER_CTRL_REG, LCDC_V1_UNDERFLOW_INT_ENA); else - tilcdc_set(dev, LCDC_INT_ENABLE_SET_REG, LCDC_V2_UNDERFLOW_INT_ENA); + tilcdc_set(dev, LCDC_INT_ENABLE_SET_REG, + LCDC_V2_UNDERFLOW_INT_ENA | + LCDC_FRAME_DONE);
return 0; } @@ -418,7 +420,7 @@ static void enable_vblank(struct drm_device *dev, bool enable) } else { reg = LCDC_INT_ENABLE_SET_REG; mask = LCDC_V2_END_OF_FRAME0_INT_ENA | - LCDC_V2_END_OF_FRAME1_INT_ENA | LCDC_FRAME_DONE; + LCDC_V2_END_OF_FRAME1_INT_ENA; }
if (enable)