This panel is used on the TI SDP3430 board.
The code is based on the omapdrm-specific panel-sharp-ls037v7dw01 driver.
Signed-off-by: Laurent Pinchart laurent.pinchart@ideasonboard.com Reviewed-by: Sam Ravnborg sam@ravnborg.org --- Changes since v1:
- Mention boards using the panel in Kconfig - Renamed ls037v7dw01_device to ls037v7dw01_panel - Renamed vcc to vdd - Comments updates - Store width_mm and height_mm in drm_display_mode - Use drm_panel_disable() in .remove() handler - Use devm_gpiod_get() where applicable - Remove NULL-check on vdd - Order Kconfig entries alphabetically --- drivers/gpu/drm/panel/Kconfig | 7 + drivers/gpu/drm/panel/Makefile | 1 + .../gpu/drm/panel/panel-sharp-ls037v7dw01.c | 226 ++++++++++++++++++ 3 files changed, 234 insertions(+) create mode 100644 drivers/gpu/drm/panel/panel-sharp-ls037v7dw01.c
diff --git a/drivers/gpu/drm/panel/Kconfig b/drivers/gpu/drm/panel/Kconfig index d28133c6aa0a..8d9a8cdb704e 100644 --- a/drivers/gpu/drm/panel/Kconfig +++ b/drivers/gpu/drm/panel/Kconfig @@ -282,6 +282,13 @@ config DRM_PANEL_SHARP_LQ101R1SX01 To compile this driver as a module, choose M here: the module will be called panel-sharp-lq101r1sx01.
+config DRM_PANEL_SHARP_LS037V7DW01 + tristate "Sharp LS037V7DW01 VGA LCD panel" + depends on GPIOLIB && OF && REGULATOR + help + Say Y here if you want to enable support for Sharp LS037V7DW01 VGA + (480x640) LCD panel (found on the TI SDP3430 board). + config DRM_PANEL_SHARP_LS043T1LE01 tristate "Sharp LS043T1LE01 qHD video mode panel" depends on OF diff --git a/drivers/gpu/drm/panel/Makefile b/drivers/gpu/drm/panel/Makefile index 8052f9a7ad60..14d1c49ef3ab 100644 --- a/drivers/gpu/drm/panel/Makefile +++ b/drivers/gpu/drm/panel/Makefile @@ -29,6 +29,7 @@ obj-$(CONFIG_DRM_PANEL_SAMSUNG_S6E63M0) += panel-samsung-s6e63m0.o obj-$(CONFIG_DRM_PANEL_SAMSUNG_S6E8AA0) += panel-samsung-s6e8aa0.o obj-$(CONFIG_DRM_PANEL_SEIKO_43WVF1G) += panel-seiko-43wvf1g.o obj-$(CONFIG_DRM_PANEL_SHARP_LQ101R1SX01) += panel-sharp-lq101r1sx01.o +obj-$(CONFIG_DRM_PANEL_SHARP_LS037V7DW01) += panel-sharp-ls037v7dw01.o obj-$(CONFIG_DRM_PANEL_SHARP_LS043T1LE01) += panel-sharp-ls043t1le01.o obj-$(CONFIG_DRM_PANEL_SITRONIX_ST7701) += panel-sitronix-st7701.o obj-$(CONFIG_DRM_PANEL_SITRONIX_ST7789V) += panel-sitronix-st7789v.o diff --git a/drivers/gpu/drm/panel/panel-sharp-ls037v7dw01.c b/drivers/gpu/drm/panel/panel-sharp-ls037v7dw01.c new file mode 100644 index 000000000000..2aaea507cc1f --- /dev/null +++ b/drivers/gpu/drm/panel/panel-sharp-ls037v7dw01.c @@ -0,0 +1,226 @@ +// SPDX-License-Identifier: GPL-2.0 +/* + * Sharp LS037V7DW01 LCD Panel Driver + * + * Copyright (C) 2019 Texas Instruments Incorporated + * + * Based on the omapdrm-specific panel-sharp-ls037v7dw01 driver + * + * Copyright (C) 2013 Texas Instruments Incorporated + * Author: Tomi Valkeinen tomi.valkeinen@ti.com + */ + +#include <linux/delay.h> +#include <linux/gpio/consumer.h> +#include <linux/module.h> +#include <linux/of.h> +#include <linux/platform_device.h> +#include <linux/regulator/consumer.h> + +#include <drm/drm_connector.h> +#include <drm/drm_modes.h> +#include <drm/drm_panel.h> + +struct ls037v7dw01_panel { + struct drm_panel panel; + struct platform_device *pdev; + + struct regulator *vdd; + struct gpio_desc *resb_gpio; /* low = reset active min 20 us */ + struct gpio_desc *ini_gpio; /* high = power on */ + struct gpio_desc *mo_gpio; /* low = 480x640, high = 240x320 */ + struct gpio_desc *lr_gpio; /* high = conventional horizontal scanning */ + struct gpio_desc *ud_gpio; /* high = conventional vertical scanning */ +}; + +#define to_ls037v7dw01_device(p) \ + container_of(p, struct ls037v7dw01_panel, panel) + +static int ls037v7dw01_disable(struct drm_panel *panel) +{ + struct ls037v7dw01_panel *lcd = to_ls037v7dw01_device(panel); + + gpiod_set_value_cansleep(lcd->ini_gpio, 0); + gpiod_set_value_cansleep(lcd->resb_gpio, 0); + + /* Wait at least 5 vsyncs after disabling the LCD. */ + msleep(100); + + return 0; +} + +static int ls037v7dw01_unprepare(struct drm_panel *panel) +{ + struct ls037v7dw01_panel *lcd = to_ls037v7dw01_device(panel); + + regulator_disable(lcd->vdd); + return 0; +} + +static int ls037v7dw01_prepare(struct drm_panel *panel) +{ + struct ls037v7dw01_panel *lcd = to_ls037v7dw01_device(panel); + int ret; + + ret = regulator_enable(lcd->vdd); + if (ret < 0) + dev_err(&lcd->pdev->dev, "%s: failed to enable regulator\n", + __func__); + + return ret; +} + +static int ls037v7dw01_enable(struct drm_panel *panel) +{ + struct ls037v7dw01_panel *lcd = to_ls037v7dw01_device(panel); + + /* Wait couple of vsyncs before enabling the LCD. */ + msleep(50); + + gpiod_set_value_cansleep(lcd->resb_gpio, 1); + gpiod_set_value_cansleep(lcd->ini_gpio, 1); + + return 0; +} + +static const struct drm_display_mode ls037v7dw01_mode = { + .clock = 19200, + .hdisplay = 480, + .hsync_start = 480 + 1, + .hsync_end = 480 + 1 + 2, + .htotal = 480 + 1 + 2 + 28, + .vdisplay = 640, + .vsync_start = 640 + 1, + .vsync_end = 640 + 1 + 1, + .vtotal = 640 + 1 + 1 + 1, + .vrefresh = 58, + .type = DRM_MODE_TYPE_DRIVER | DRM_MODE_TYPE_PREFERRED, + .flags = DRM_MODE_FLAG_NHSYNC | DRM_MODE_FLAG_NVSYNC, + .width_mm = 56, + .height_mm = 75, +}; + +static int ls037v7dw01_get_modes(struct drm_panel *panel) +{ + struct drm_connector *connector = panel->connector; + struct drm_display_mode *mode; + + mode = drm_mode_duplicate(panel->drm, &ls037v7dw01_mode); + if (!mode) + return -ENOMEM; + + drm_mode_set_name(mode); + drm_mode_probed_add(connector, mode); + + connector->display_info.width_mm = ls037v7dw01_mode.width_mm; + connector->display_info.height_mm = ls037v7dw01_mode.height_mm; + /* + * FIXME: According to the datasheet pixel data is sampled on the + * rising edge of the clock, but the code running on the SDP3430 + * indicates sampling on the negative edge. This should be tested on a + * real device. + */ + connector->display_info.bus_flags = DRM_BUS_FLAG_DE_HIGH + | DRM_BUS_FLAG_SYNC_SAMPLE_POSEDGE + | DRM_BUS_FLAG_PIXDATA_SAMPLE_NEGEDGE; + + return 1; +} + +static const struct drm_panel_funcs ls037v7dw01_funcs = { + .disable = ls037v7dw01_disable, + .unprepare = ls037v7dw01_unprepare, + .prepare = ls037v7dw01_prepare, + .enable = ls037v7dw01_enable, + .get_modes = ls037v7dw01_get_modes, +}; + +static int ls037v7dw01_probe(struct platform_device *pdev) +{ + struct ls037v7dw01_panel *lcd; + + lcd = devm_kzalloc(&pdev->dev, sizeof(*lcd), GFP_KERNEL); + if (lcd == NULL) + return -ENOMEM; + + platform_set_drvdata(pdev, lcd); + lcd->pdev = pdev; + + lcd->vdd = devm_regulator_get(&pdev->dev, "envdd"); + if (IS_ERR(lcd->vdd)) { + dev_err(&pdev->dev, "failed to get regulator\n"); + return PTR_ERR(lcd->vdd); + } + + lcd->ini_gpio = devm_gpiod_get(&pdev->dev, "enable", GPIOD_OUT_LOW); + if (IS_ERR(lcd->ini_gpio)) { + dev_err(&pdev->dev, "failed to get enable gpio\n"); + return PTR_ERR(lcd->ini_gpio); + } + + lcd->resb_gpio = devm_gpiod_get(&pdev->dev, "reset", GPIOD_OUT_LOW); + if (IS_ERR(lcd->resb_gpio)) { + dev_err(&pdev->dev, "failed to get reset gpio\n"); + return PTR_ERR(lcd->resb_gpio); + } + + lcd->mo_gpio = devm_gpiod_get_index(&pdev->dev, "mode", 0, + GPIOD_OUT_LOW); + if (IS_ERR(lcd->mo_gpio)) { + dev_err(&pdev->dev, "failed to get mode[0] gpio\n"); + return PTR_ERR(lcd->mo_gpio); + } + + lcd->lr_gpio = devm_gpiod_get_index(&pdev->dev, "mode", 1, + GPIOD_OUT_LOW); + if (IS_ERR(lcd->lr_gpio)) { + dev_err(&pdev->dev, "failed to get mode[1] gpio\n"); + return PTR_ERR(lcd->lr_gpio); + } + + lcd->ud_gpio = devm_gpiod_get_index(&pdev->dev, "mode", 2, + GPIOD_OUT_LOW); + if (IS_ERR(lcd->ud_gpio)) { + dev_err(&pdev->dev, "failed to get mode[2] gpio\n"); + return PTR_ERR(lcd->ud_gpio); + } + + drm_panel_init(&lcd->panel); + lcd->panel.dev = &pdev->dev; + lcd->panel.funcs = &ls037v7dw01_funcs; + + return drm_panel_add(&lcd->panel); +} + +static int ls037v7dw01_remove(struct platform_device *pdev) +{ + struct ls037v7dw01_panel *lcd = platform_get_drvdata(pdev); + + drm_panel_remove(&lcd->panel); + drm_panel_disable(&lcd->panel); + drm_panel_unprepare(&lcd->panel); + + return 0; +} + +static const struct of_device_id ls037v7dw01_of_match[] = { + { .compatible = "sharp,ls037v7dw01", }, + { /* sentinel */ }, +}; + +MODULE_DEVICE_TABLE(of, ls037v7dw01_of_match); + +static struct platform_driver ls037v7dw01_driver = { + .probe = ls037v7dw01_probe, + .remove = __exit_p(ls037v7dw01_remove), + .driver = { + .name = "panel-sharp-ls037v7dw01", + .of_match_table = ls037v7dw01_of_match, + }, +}; + +module_platform_driver(ls037v7dw01_driver); + +MODULE_AUTHOR("Tomi Valkeinen tomi.valkeinen@ti.com"); +MODULE_DESCRIPTION("Sharp LS037V7DW01 Panel Driver"); +MODULE_LICENSE("GPL");