"qcom,dsi-host-index" and "qcom,dsi-phy-index" DT props aren't acceptable and have never been used in any DT files. Remove them.
Cc: Rob Herring robh@kernel.org Cc: devicetree@vger.kernel.org Signed-off-by: Archit Taneja architt@codeaurora.org --- Documentation/devicetree/bindings/display/msm/dsi.txt | 4 ---- 1 file changed, 4 deletions(-)
diff --git a/Documentation/devicetree/bindings/display/msm/dsi.txt b/Documentation/devicetree/bindings/display/msm/dsi.txt index a6671bd2c85a..457c688736be 100644 --- a/Documentation/devicetree/bindings/display/msm/dsi.txt +++ b/Documentation/devicetree/bindings/display/msm/dsi.txt @@ -7,8 +7,6 @@ Required properties: - reg: Physical base address and length of the registers of controller - reg-names: The names of register regions. The following regions are required: * "dsi_ctrl" -- qcom,dsi-host-index: The ID of DSI controller hardware instance. This should - be 0 or 1, since we have 2 DSI controllers at most for now. - interrupts: The interrupt signal from the DSI block. - power-domains: Should be <&mmcc MDSS_GDSC>. - clocks: Phandles to device clocks. @@ -96,8 +94,6 @@ Required properties: * "dsi_phy_regulator" - clock-cells: Must be 1. The DSI PHY block acts as a clock provider, creating 2 clocks: A byte clock (index 0), and a pixel clock (index 1). -- qcom,dsi-phy-index: The ID of DSI PHY hardware instance. This should - be 0 or 1, since we have 2 DSI PHYs at most for now. - power-domains: Should be <&mmcc MDSS_GDSC>. - clocks: Phandles to device clocks. See [1] for details on clock bindings. - clock-names: the following clocks are required: