Hi Denis,
On 04/07/2014 02:44 PM, Denis Carikli wrote:
We need a way to pass signal polarity informations between DRM panels, and the display drivers.
To do that, a pol_flags field was added to drm_display_mode.
Signed-off-by: Denis Carikli denis@eukrea.com
ChangeLog v11->v12:
- Rebased: This patch now applies against drm_modes.h
- Rebased: It now uses the new DRM_MODE_FLAG_POL_DE flags defines names
ChangeLog v10->v11:
Since the imx-drm won't be able to retrive its regulators from the device tree when using display-timings nodes, and that I was told that the drm simple-panel driver already supported that, I then, instead, added what was lacking to make the eukrea displays work with the drm-simple-panel driver.
That required a way to get back the display polarity informations from the imx-drm driver without affecting userspace.
include/drm/drm_modes.h | 8 ++++++++ 1 file changed, 8 insertions(+)
diff --git a/include/drm/drm_modes.h b/include/drm/drm_modes.h index 2dbbf99..b3789e2 100644 --- a/include/drm/drm_modes.h +++ b/include/drm/drm_modes.h @@ -93,6 +93,13 @@ enum drm_mode_status {
#define DRM_MODE_FLAG_3D_MAX DRM_MODE_FLAG_3D_SIDE_BY_SIDE_HALF
+#define DRM_MODE_FLAG_POL_PIXDATA_NEGEDGE BIT(1) +#define DRM_MODE_FLAG_POL_PIXDATA_POSEDGE BIT(2) +#define DRM_MODE_FLAG_POL_PIXDATA_PRESERVE BIT(3)
What is the purpose of DRM_MODE_FLAG_POL_PIXDATA_PRESERVE? If 'preserve' means 'ignore' we can set to zero negedge and posedge bits instead of adding new bit. If it is something different please describe it.
+#define DRM_MODE_FLAG_POL_DE_LOW BIT(4) +#define DRM_MODE_FLAG_POL_DE_HIGH BIT(5) +#define DRM_MODE_FLAG_POL_DE_PRESERVE BIT(6)
The same comments here.
struct drm_display_mode { /* Header */ struct list_head head; @@ -144,6 +151,7 @@ struct drm_display_mode { int vrefresh; /* in Hz */ int hsync; /* in kHz */ enum hdmi_picture_aspect picture_aspect_ratio;
- unsigned int pol_flags;
Adding field and macros description to the DocBook would be nice.
Regards Andrzej
};
/* mode specified on the command line */