Re: [PATCH 09/10] dt-bindings: video: exynos5433-decon: add bindings for DECON-TV

W dniu 20.10.2015 o 18:22, Andrzej Hajda pisze:

DECON-TV(Display and Enhancement Controller for TV) is a variation of DECON IP. Its main purpose is to produce video stream for HDMI IP.

Signed-off-by: Andrzej Hajda a.hajda@samsung.com

.../devicetree/bindings/video/exynos5433-decon.txt | 21 ++++++++++++--------- 1 file changed, 12 insertions(+), 9 deletions(-)

diff --git a/Documentation/devicetree/bindings/video/exynos5433-decon.txt b/Documentation/devicetree/bindings/video/exynos5433-decon.txt index 3dff78b..2a88c8d 100644 --- a/Documentation/devicetree/bindings/video/exynos5433-decon.txt +++ b/Documentation/devicetree/bindings/video/exynos5433-decon.txt @@ -5,24 +5,27 @@ Exynos series of SoCs which transfers the image data from a video memory buffer to an external LCD interface.

Required properties: -- compatible: value should be "samsung,exynos5433-decon"; +- compatible: value should be one of:

• "samsung,exynos5433-decon", "samsung,exynos5433-decon-tv";

Until this point it looked good.

• reg: physical base address and length of the DECON registers set.

-- interrupts: should contain a list of all DECON IP block interrupts in the

•      order: VSYNC, LCD_SYSTEM. The interrupt specifier format
  

•      depends on the interrupt controller used.
  

-- interrupt-names: should contain the interrupt names: "vsync", "lcd_sys"

•    in the same order as they were listed in the interrupts
  

•    property.
  

+- interrupts: should contain interrupt specifier of VSYNC and optionally

•      LCD_SYSTEM. The interrupt specifier format depends on
  

•      the interrupt controller used.
  

+- interrupt-names: should contain the interrupt name "vsync" and optionally

•    "lcd_sys" in the same order as they were listed in
  

•    the interrupts property.
  

The driver already did not require both interrupts, right? Only one of them?

• clocks: must include clock specifiers corresponding to entries in the clock-names property.
• clock-names: list of clock names sorted in the same order as the clocks property. Must contain "pclk", "aclk_decon", "aclk_smmu_decon0x", "aclk_xiu_decon0x", "pclk_smmu_decon0x", clk_decon_vclk", "sclk_decon_eclk"

+Optional properties:

• ports: contains a port which is connected to mic node. address-cells and

• size-cells must 1 and 0, respectively.
  

• size-cells must be 1 and 0, respectively.
  

• port: contains an endpoint node which is connected to the endpoint in the mic
• node. The reg value muset be 0.

• node. The reg value must be 0.

• i80-if-timings: specify whether the panel which is connected to decon uses i80 lcd interface or mipi video interface. This node contains no timing information as that of fimd does. Because there is

This is cleanup, please split it.

Best regards, Krzysztof