inno_hdmi_phy_rk3328_clk_set_rate() is using the RK3228 macro when configuring vco_div_5 on RK3328.
Fix this by using correct vco_div_5 macro for RK3328.
Fixes: 53706a116863 ("phy: add Rockchip Innosilicon hdmi phy") Signed-off-by: Jonas Karlman jonas@kwiboo.se --- drivers/phy/rockchip/phy-rockchip-inno-hdmi.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/phy/rockchip/phy-rockchip-inno-hdmi.c b/drivers/phy/rockchip/phy-rockchip-inno-hdmi.c index 9ca20c947283..b0ac1d3ee390 100644 --- a/drivers/phy/rockchip/phy-rockchip-inno-hdmi.c +++ b/drivers/phy/rockchip/phy-rockchip-inno-hdmi.c @@ -790,8 +790,8 @@ static int inno_hdmi_phy_rk3328_clk_set_rate(struct clk_hw *hw, RK3328_PRE_PLL_POWER_DOWN);
/* Configure pre-pll */ - inno_update_bits(inno, 0xa0, RK3228_PCLK_VCO_DIV_5_MASK, - RK3228_PCLK_VCO_DIV_5(cfg->vco_div_5_en)); + inno_update_bits(inno, 0xa0, RK3328_PCLK_VCO_DIV_5_MASK, + RK3328_PCLK_VCO_DIV_5(cfg->vco_div_5_en)); inno_write(inno, 0xa1, RK3328_PRE_PLL_PRE_DIV(cfg->prediv));
val = RK3328_SPREAD_SPECTRUM_MOD_DISABLE;