On 03/13/2013 06:04 PM, Inki Dae wrote:
From: YoungJun Cho yj44.cho@samsung.com
This patch fixes G2D core mulfunctioning issue once g2d dma is started. Without 'DMA_HOLD_CMD_REG' register setting, there is only one interrupt after the execution to all command lists have been completed. And that induces watchdog. So this patch sets 'LIST_HOLD' command to the register so that command execution interrupt can be occured whenever each command list execution is finished.
No, this problem occurs as GCF bit of INTEN_REG register is enabled always. If wants to raise interrupt immediately after a command list finished, GCF bit should be enabled, and it also needs to enable of LIST Hold bit of DMA_HOLD_CMD_REG register. If one of the two is missed out, g2d hardware will not work normally sometimes.
This patch is just workaround and it can happen performance issue because g2d hardware stops a moment whenever a command list finished.
So, we need the way which enable GCF bit only when a command list completion interrupt needs.
Thanks.
Signed-off-by: YoungJun Cho yj44.cho@samsung.com Signed-off-by: Inki Dae inki.dae@samsung.com Signed-off-by: Kyungmin Park kyungmin.park@samsung.com
drivers/gpu/drm/exynos/exynos_drm_g2d.c | 13 ++++++++----- 1 files changed, 8 insertions(+), 5 deletions(-)
diff --git a/drivers/gpu/drm/exynos/exynos_drm_g2d.c b/drivers/gpu/drm/exynos/exynos_drm_g2d.c index 095520f..91bc4cc 100644 --- a/drivers/gpu/drm/exynos/exynos_drm_g2d.c +++ b/drivers/gpu/drm/exynos/exynos_drm_g2d.c @@ -82,7 +82,7 @@ #define G2D_DMA_LIST_DONE_COUNT_OFFSET 17
/* G2D_DMA_HOLD_CMD */ -#define G2D_USET_HOLD (1 << 2) +#define G2D_USER_HOLD (1 << 2) #define G2D_LIST_HOLD (1 << 1) #define G2D_BITBLT_HOLD (1 << 0)
@@ -863,10 +863,13 @@ int exynos_g2d_set_cmdlist_ioctl(struct drm_device *drm_dev, void *data, cmdlist->data[cmdlist->last++] = G2D_SRC_BASE_ADDR; cmdlist->data[cmdlist->last++] = 0;
- if (node->event) {
cmdlist->data[cmdlist->last++] = G2D_DMA_HOLD_CMD;cmdlist->data[cmdlist->last++] = G2D_LIST_HOLD;- }
/*
* 'LIST_HOLD' command should be set to the DMA_HOLD_CMD_REG* if user wants G2D interrupt event once each command list or* BitBLT command execution is finished.*/cmdlist->data[cmdlist->last++] = G2D_DMA_HOLD_CMD;
cmdlist->data[cmdlist->last++] = G2D_LIST_HOLD;
/* Check size of cmdlist: last 2 is about G2D_BITBLT_START */ size = cmdlist->last + req->cmd_nr * 2 + req->cmd_buf_nr * 2 + 2;