Add DT bindings documentmation for the HDP-TX PHY controller. The describes which could be found on NXP Layerscape ls1028a platform.
Signed-off-by: Wen He wen.he_1@nxp.com --- change in v2: - correction the node name.
.../devicetree/bindings/display/fsl,hdp.txt | 56 +++++++++++++++++++ 1 file changed, 56 insertions(+) create mode 100644 Documentation/devicetree/bindings/display/fsl,hdp.txt
diff --git a/Documentation/devicetree/bindings/display/fsl,hdp.txt b/Documentation/devicetree/bindings/display/fsl,hdp.txt new file mode 100644 index 000000000000..53ca08337587 --- /dev/null +++ b/Documentation/devicetree/bindings/display/fsl,hdp.txt @@ -0,0 +1,56 @@ +NXP Layerscpae ls1028a HDP-TX PHY Controller +============================================ + +The following bindings describe the Cadence HDP TX PHY on ls1028a that +offer multi-protocol support of standars such as eDP and Displayport, +supports for 25-600MHz pixel clock and up to 4k2k at 60MHz resolution. +The HDP transmitter is a Cadence HDP TX controller IP with a companion +PHY IP. + +Required properties: + - compatible: Should be "fsl,ls1028a-dp" for ls1028a. + - reg: Physical base address and size of the block of registers used + by the processor. + - interrupts: HDP hotplug in/out detect interrupt number + - clocks: A list of phandle + clock-specifier pairs, one for each entry + in 'clock-names' + - clock-names: A list of clock names. It should contain: + - "clk_ipg": inter-Integrated circuit clock + - "clk_core": for the Main Display TX controller clock + - "clk_pxl": for the pixel clock feeding the output PLL of the processor + - "clk_pxl_mux": for the high PerfPLL bypass clock + - "clk_pxl_link": for the link rate pixel clock + - "clk_apb": for the APB interface clock + - "clk_vif": for the Video pixel clock + +Required sub-nodes: + - port: The HDP connection to an encoder output port. The connection + is modelled using the OF graph bindings specified in + Documentation/devicetree/bindings/graph.txt + + +Example: + +/ { + ... + + hdptx0: display@f200000 { + compatible = "fsl,ls1028a-dp"; + reg = <0x0 0xf1f0000 0x0 0xffff>, + <0x0 0xf200000 0x0 0xfffff>; + interrupts = <0 221 IRQ_TYPE_LEVEL_HIGH>; + clocks = <&sysclk>, <&hdpclk>, <&dpclk>, + <&dpclk>, <&dpclk>, <&pclk>, <&dpclk>; + clock-names = "clk_ipg", "clk_core", "clk_pxl", + "clk_pxl_mux", "clk_pxl_link", "clk_apb", + "clk_vif"; + + port { + dp1_output: endpoint { + remote-endpoint = <&dp0_input>; + }; + }; + }; + + ... +};