From: Rob Clark rob@ti.com

The "OMAPDSS: HDMI: PHY burnout fix" commit switched the HDMI driver over to using a GPIO for plug detect. Unfortunately the ->detect() method was not also updated, causing HDMI to no longer work for the omapdrm driver (because it would actually check if a connection was detected before attempting to enable display).

Signed-off-by: Rob Clark rob@ti.com --- drivers/video/omap2/dss/ti_hdmi_4xxx_ip.c | 9 +-------- 1 files changed, 1 insertions(+), 8 deletions(-)

diff --git a/drivers/video/omap2/dss/ti_hdmi_4xxx_ip.c b/drivers/video/omap2/dss/ti_hdmi_4xxx_ip.c index 2d72334..6847a47 100644 --- a/drivers/video/omap2/dss/ti_hdmi_4xxx_ip.c +++ b/drivers/video/omap2/dss/ti_hdmi_4xxx_ip.c @@ -479,14 +479,7 @@ int ti_hdmi_4xxx_read_edid(struct hdmi_ip_data *ip_data,

bool ti_hdmi_4xxx_detect(struct hdmi_ip_data *ip_data) { - int r; - - void __iomem *base = hdmi_core_sys_base(ip_data); - - /* HPD */ - r = REG_GET(base, HDMI_CORE_SYS_SYS_STAT, 1, 1); - - return r == 1; + return gpio_get_value(ip_data->hpd_gpio); }

static void hdmi_core_init(struct hdmi_core_video_config *video_cfg,