On Fri, May 7, 2021 at 2:44 PM Pi-Hsun Shih pihsun@chromium.org wrote:

The driver originally use an atomic_t for keep track of the power status, which makes the driver more complicated than needed, and has some race condition as it's possible to have the power on and power off sequence going at the same time.

This patch remove the usage of the atomic_t power_status, and use the kernel runtime power management framework instead.

Signed-off-by: Pi-Hsun Shih pihsun@chromium.org

drivers/gpu/drm/bridge/analogix/anx7625.c | 148 +++++++++------------- drivers/gpu/drm/bridge/analogix/anx7625.h | 1 - 2 files changed, 63 insertions(+), 86 deletions(-)

diff --git a/drivers/gpu/drm/bridge/analogix/anx7625.c b/drivers/gpu/drm/bridge/analogix/anx7625.c index 23283ba0c4f9..f56f8cf1f3bd 100644 --- a/drivers/gpu/drm/bridge/analogix/anx7625.c +++ b/drivers/gpu/drm/bridge/analogix/anx7625.c @@ -11,6 +11,7 @@ #include <linux/kernel.h> #include <linux/module.h> #include <linux/mutex.h> +#include <linux/pm_runtime.h> #include <linux/regulator/consumer.h> #include <linux/slab.h> #include <linux/types.h> @@ -1005,33 +1006,6 @@ static void anx7625_power_on_init(struct anx7625_data *ctx) } }

-static void anx7625_chip_control(struct anx7625_data *ctx, int state) -{

•   struct device *dev = &ctx->client->dev;
  

•   DRM_DEV_DEBUG_DRIVER(dev, "before set, power_state(%d).\n",
  

•                        atomic_read(&ctx->power_status));
  

•   if (!ctx->pdata.low_power_mode)
  

•           return;
  

•   if (state) {
  

•           atomic_inc(&ctx->power_status);
  

•           if (atomic_read(&ctx->power_status) == 1)
  

•                   anx7625_power_on_init(ctx);
  

•   } else {
  

•           if (atomic_read(&ctx->power_status)) {
  

•                   atomic_dec(&ctx->power_status);
  

•                   if (atomic_read(&ctx->power_status) == 0)
  

•                           anx7625_power_standby(ctx);
  

•           }
  

•   }
  

•   DRM_DEV_DEBUG_DRIVER(dev, "after set, power_state(%d).\n",
  

•                        atomic_read(&ctx->power_status));
  

-}

static void anx7625_init_gpio(struct anx7625_data *platform) { struct device *dev = &platform->client->dev; @@ -1061,9 +1035,6 @@ static void anx7625_stop_dp_work(struct anx7625_data *ctx) ctx->hpd_status = 0; ctx->hpd_high_cnt = 0; ctx->display_timing_valid = 0;

•   if (ctx->pdata.low_power_mode == 0)
  

•           anx7625_disable_pd_protocol(ctx);
  

}

static void anx7625_start_dp_work(struct anx7625_data *ctx) @@ -1105,49 +1076,26 @@ static void anx7625_hpd_polling(struct anx7625_data *ctx) int ret, val; struct device *dev = &ctx->client->dev;

•   if (atomic_read(&ctx->power_status) != 1) {
  

•           DRM_DEV_DEBUG_DRIVER(dev, "No need to poling HPD status.\n");
  

•           return;
  

•   }
  

•   ret = readx_poll_timeout(anx7625_read_hpd_status_p0,
                             ctx, val,
                             ((val & HPD_STATUS) || (val < 0)),
                             5000,
                             5000 * 100);
    if (ret) {
  

•           DRM_DEV_ERROR(dev, "HPD polling timeout!\n");
  

•   } else {
  

•           DRM_DEV_DEBUG_DRIVER(dev, "HPD raise up.\n");
  

•           anx7625_reg_write(ctx, ctx->i2c.tcpc_client,
  

•                             INTR_ALERT_1, 0xFF);
  

•           anx7625_reg_write(ctx, ctx->i2c.rx_p0_client,
  

•                             INTERFACE_CHANGE_INT, 0);
  

•           DRM_DEV_ERROR(dev, "no hpd.\n");
  

•           return;
    }
  
  

•   anx7625_start_dp_work(ctx);
  

-}

-static void anx7625_disconnect_check(struct anx7625_data *ctx) -{

•   if (atomic_read(&ctx->power_status) == 0)
  

•           anx7625_stop_dp_work(ctx);
  

-}

-static void anx7625_low_power_mode_check(struct anx7625_data *ctx,

•                                    int state)
  

-{

•   struct device *dev = &ctx->client->dev;
  

•   DRM_DEV_DEBUG_DRIVER(dev, "system status: 0x%x. HPD raise up.\n", val);
  

•   anx7625_reg_write(ctx, ctx->i2c.tcpc_client,
  

•                     INTR_ALERT_1, 0xFF);
  

•   anx7625_reg_write(ctx, ctx->i2c.rx_p0_client,
  

•                     INTERFACE_CHANGE_INT, 0);
  
  

•   DRM_DEV_DEBUG_DRIVER(dev, "low power mode check, state(%d).\n", state);
  

•   anx7625_start_dp_work(ctx);
  
  

•   if (ctx->pdata.low_power_mode) {
  

•           anx7625_chip_control(ctx, state);
  

•           if (state)
  

•                   anx7625_hpd_polling(ctx);
  

•           else
  

•                   anx7625_disconnect_check(ctx);
  

•   }
  

•   if (!ctx->pdata.panel_bridge && ctx->bridge_attached)
  

•           drm_helper_hpd_irq_event(ctx->bridge.dev);
  

}

static void anx7625_remove_edid(struct anx7625_data *ctx) @@ -1180,9 +1128,6 @@ static int anx7625_hpd_change_detect(struct anx7625_data *ctx) int intr_vector, status; struct device *dev = &ctx->client->dev;

•   DRM_DEV_DEBUG_DRIVER(dev, "power_status=%d\n",
  

•                        (u32)atomic_read(&ctx->power_status));
  

•   status = anx7625_reg_write(ctx, ctx->i2c.tcpc_client,
                               INTR_ALERT_1, 0xFF);
    if (status < 0) {
  

@@ -1228,22 +1173,25 @@ static void anx7625_work_func(struct work_struct *work) struct anx7625_data, work);

    mutex_lock(&ctx->lock);

•   if (pm_runtime_suspended(&ctx->client->dev))
  

•           goto unlock;
  

•   event = anx7625_hpd_change_detect(ctx);
  

•   mutex_unlock(&ctx->lock);
    if (event < 0)
  

•           return;
  

•           goto unlock;
  
    if (ctx->bridge_attached)
            drm_helper_hpd_irq_event(ctx->bridge.dev);
  

+unlock:

•   mutex_unlock(&ctx->lock);
  

}

static irqreturn_t anx7625_intr_hpd_isr(int irq, void *data) { struct anx7625_data *ctx = (struct anx7625_data *)data;

•   if (atomic_read(&ctx->power_status) != 1)
  

•           return IRQ_NONE;
  

•   queue_work(ctx->workqueue, &ctx->work);
  
    return IRQ_HANDLED;
  

@@ -1305,9 +1253,9 @@ static struct edid *anx7625_get_edid(struct anx7625_data *ctx) return (struct edid *)edid; }

•   anx7625_low_power_mode_check(ctx, 1);
  

•   pm_runtime_get_sync(dev);
    edid_num = sp_tx_edid_read(ctx, p_edid->edid_raw_data);
  

•   anx7625_low_power_mode_check(ctx, 0);
  

•   pm_runtime_put(dev);
  
    if (edid_num < 1) {
            DRM_DEV_ERROR(dev, "Fail to read EDID: %d\n", edid_num);
  

@@ -1611,10 +1559,7 @@ static void anx7625_bridge_enable(struct drm_bridge *bridge)

    DRM_DEV_DEBUG_DRIVER(dev, "drm enable\n");

•   anx7625_low_power_mode_check(ctx, 1);
  

•   if (WARN_ON(!atomic_read(&ctx->power_status)))
  

•           return;
  

•   pm_runtime_get_sync(dev);
  
    anx7625_dp_start(ctx);
  

} @@ -1624,14 +1569,11 @@ static void anx7625_bridge_disable(struct drm_bridge *bridge) struct anx7625_data *ctx = bridge_to_anx7625(bridge); struct device *dev = &ctx->client->dev;

•   if (WARN_ON(!atomic_read(&ctx->power_status)))
  

•           return;
  

•   DRM_DEV_DEBUG_DRIVER(dev, "drm disable\n");
  
    anx7625_dp_stop(ctx);
  
  

•   anx7625_low_power_mode_check(ctx, 0);
  

•   pm_runtime_put(dev);
  

}

static enum drm_connector_status @@ -1735,6 +1677,39 @@ static void anx7625_unregister_i2c_dummy_clients(struct anx7625_data *ctx) i2c_unregister_device(ctx->i2c.tcpc_client); }

+static int __maybe_unused anx7625_runtime_pm_suspend(struct device *dev) +{

•   struct anx7625_data *ctx = dev_get_drvdata(dev);
  

•   mutex_lock(&ctx->lock);
  

•   anx7625_stop_dp_work(ctx);
  

•   anx7625_power_standby(ctx);
  

•   mutex_unlock(&ctx->lock);
  

•   return 0;
  

+}

+static int __maybe_unused anx7625_runtime_pm_resume(struct device *dev) +{

•   struct anx7625_data *ctx = dev_get_drvdata(dev);
  

•   mutex_lock(&ctx->lock);
  

•   anx7625_power_on_init(ctx);
  

•   anx7625_hpd_polling(ctx);
  

•   mutex_unlock(&ctx->lock);
  

•   return 0;
  

+}

+static const struct dev_pm_ops anx7625_pm_ops = {

•   SET_RUNTIME_PM_OPS(anx7625_runtime_pm_suspend,
  

•                      anx7625_runtime_pm_resume, NULL)
  

+};

.pm = &anx7625_pm_ops, is missing in static struct i2c_driver anx7625_driver{...}

static int anx7625_i2c_probe(struct i2c_client *client, const struct i2c_device_id *id) { @@ -1778,8 +1753,6 @@ static int anx7625_i2c_probe(struct i2c_client *client, } anx7625_init_gpio(platform);

•   atomic_set(&platform->power_status, 0);
  

•   mutex_init(&platform->lock);
  
    platform->pdata.intp_irq = client->irq;
  

@@ -1809,9 +1782,11 @@ static int anx7625_i2c_probe(struct i2c_client *client, goto free_wq; }

•   if (platform->pdata.low_power_mode == 0) {
  

•   pm_runtime_enable(dev);
  

•   if (!platform->pdata.low_power_mode) {
            anx7625_disable_pd_protocol(platform);
  

•           atomic_set(&platform->power_status, 1);
  

•           pm_runtime_get_sync(dev);
    }
  
    /* Add work function */
  

@@ -1847,6 +1822,9 @@ static int anx7625_i2c_remove(struct i2c_client *client) if (platform->pdata.intp_irq) destroy_workqueue(platform->workqueue);

•   if (!platform->pdata.low_power_mode)
  

•           pm_runtime_put_sync_suspend(&client->dev);
  

•   anx7625_unregister_i2c_dummy_clients(platform);
  
    kfree(platform);
  

diff --git a/drivers/gpu/drm/bridge/analogix/anx7625.h b/drivers/gpu/drm/bridge/analogix/anx7625.h index e4a086b3a3d7..034c3840028f 100644 --- a/drivers/gpu/drm/bridge/analogix/anx7625.h +++ b/drivers/gpu/drm/bridge/analogix/anx7625.h @@ -369,7 +369,6 @@ struct anx7625_i2c_client {

struct anx7625_data { struct anx7625_platform_data pdata;

•   atomic_t power_status;
    int hpd_status;
    int hpd_high_cnt;
    /* Lock for work queue */
  
  

base-commit: e48661230cc35b3d0f4367eddfc19f86463ab917

2.31.1.607.g51e8a6a459-goog